MODELROCK Kit Ready Lashes #299s are natural volume lashe with criss-crossed wispy lash design providing natural look with gradient thickness toward the outer corners. *Lash Discovery Box item*
MODELROCK LASHES Kit Ready #299
Lash Size Chart
-
Lash Band Length = 3.1cm
-
Inner hair length = 4mm
-
Mid point hair length = 8mm
-
Outer corner hair length = 10mm
MODELROCK Lash #299s (MRL0806 / MRL299s)
100% Hand-Made - 100% Human hair lashes
**Adhesive NOT included - Adhesive Can be purchased separately**
Here's your perfect Modelrock fauxies in simple steps:
1) Start with a clean, dry eye area. Curl your natural eyelashes with a lash curler as needed.
2) Take one lash from lash tray. Hold it up to your eyelid to approximate to make sure it fits your eye. If the lash band is too long, trim from the shorter inner end.
3) Apply a very thin line of strip glue directly onto the lash band.
4) Let the glue dry for about 20 to 30 seconds. The desired glue consistency should be moderately dry (tacky).
5) Apply by getting as close as possible to your lash line and gently press the lash band from the inner corner out to the outer corner of your eye. You can use the end of a thin makeup brush to scoot it closer before the glue sets. The goal is to leave as little space between the lash strip and your lash line for the most natural look.
6) Let it dry with that eye closed for about a minute so any excess glue doesn't travel up to your lid. If it does, remove it with a little makeup remover on a Q-tip.
7) Repeat this process on the other eye.
8) Let both dry a few minutes, then proceed with liner, shadow (if desired), and one or two coats of mascara to blend in your falsies with your natural lashes for the perfect lash heads turn look!
Previous Page
Recently Viewed
